DM-EEP-SPI-4M
Ask about this product
Send your application details and get a specification answer within one business day.
I²C EEPROM, 256 Kbit, 1.7–5.5 V, SOIC-8
256 Kbit serial EEPROM on I²C, 1.7 to 5.5 V, 1 MHz bus, 3.5 ms page write. Two-wire interface with three address pins, for calibration data, serial numbers and configuration that must survive power loss.
| Parameter | Value | Unit |
|---|---|---|
| Density | 256 | Kbit (32 KB) |
| Interface | I²C, up to 1 MHz | |
| Supply voltage | 1.7 to 5.5 | V |
| Page size | 64 | bytes |
| Write cycle time | 3.5 | ms maximum |
| Endurance | 1,000,000 | write cycles per byte |
| Data retention | 200 | years |
| Address pins | A0 to A2, up to 8 devices on one bus | |
| Standby current | 1 | µA at 3.3 V |
| Package | SOIC-8 |
Overview
EEPROM is the only common non-volatile memory that writes a single byte without erasing a sector first. That is why it survives in designs where flash would be simpler: when the firmware has to store a counter, a calibration offset or a last-known state every few seconds, byte-write granularity is what keeps the endurance budget manageable.
The 3.5 ms write time is the constraint that shapes the firmware. A page write of 64 bytes takes the same 3.5 ms as a single byte, so data should be batched into pages rather than written field by field. The part also does not acknowledge during the internal write, which means the driver has to poll rather than assume the next transaction will succeed.
Key features
- 256 Kbit organised as 32,768 bytes, 512 pages of 64 bytes
- 1.7 to 5.5 V supply, so it runs on 1.8 V, 3.3 V and 5 V rails
- 1 MHz I²C bus, fast mode plus compatible
- Three address pins allow eight devices on one bus
- Hardware write-protect pin for the upper quadrant
Typical applications
- Calibration coefficients and sensor offsets
- Serial numbers, MAC addresses and board identity
- User settings and last-known operating state
- Event and fault counters
Selection note
Budget the endurance before choosing a part. One write per second to the same byte reaches a million cycles in eleven days. Rotate the write address across a page, or cache in RAM and flush on power-down, when the update rate is high.
Ordering
Send the density, bus voltage, expected write frequency and address count. We confirm the endurance strategy and package, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-SRAM-SPI-512K
SPI SRAM, 512 Kbit, 20 MHz, SOIC-8
DM-FLS-NOR-64M