DM-SW-T6-SMD
Ask about this product
Send your application details and get a specification answer within one business day.
Illuminated Pushbutton, 16 mm, 1NO, 24 V LED, IP65
16 mm panel-mount illuminated pushbutton, single normally-open contact, 3 A at 250 V AC, 24 V ring LED and IP65 front seal. For start, stop and reset functions that must be visible from across a room.
| Parameter | Value | Unit |
|---|---|---|
| Panel cutout | 16 | mm |
| Contact configuration | 1NO, momentary | |
| Contact rating | 3 | A at 250 V AC |
| LED voltage | 24 | V DC, ring illumination |
| LED current | 20 | mA |
| Front protection | IP65 | |
| Mechanical life | 1,000,000 | operations |
| Electrical life | 50,000 | operations at rated load |
| Termination | Screw or 4.8 mm spade | |
| Bezel | 22 mm outer diameter |
Overview
An illuminated pushbutton combines the operator input and the status indication in one hole. On a wash-down panel that matters: every additional indicator is another seal to fail, and a button that lights when the pump is running removes the need for a separate lamp.
The IP65 rating applies to the front face only, which is what the standard describes. The rear terminals are not sealed, so the enclosure behind the panel still has to be rated for the environment. Assuming the button seals the whole panel is a common and expensive mistake.
Key features
- Integrated ring illumination replaces a separate indicator
- 16 mm cutout, 22 mm bezel, standard industrial footprint
- 3 A at 250 V AC contact rating for direct control
- IP65 front seal for wash-down panels
- Screw or spade terminals, no special tooling
Typical applications
- Start, stop and reset stations
- Pump and valve control panels
- Machine mode selection with status feedback
- Emergency acknowledge and alarm reset
Selection note
Confirm the LED voltage against the panel supply before ordering. A 24 V button on a 12 V circuit will glow dimly and a 12 V button on 24 V will fail; both look identical from the front.
Ordering
Send the panel cutout, contact configuration, coil or LED voltage and required IP rating. We confirm the bezel and terminal type, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-SW-T12-THT
Tactile Switch, 12 × 12 mm, Through-Hole, 260 gf, 500k Cycles
DM-SW-SPDT-254