DM-SW-T6-SMD
Ask about this product
Send your application details and get a specification answer within one business day.
Slide Switch, SPDT, 2.54 mm Pitch, 500 mA, 10k Cycles
SPDT slide switch on a 2.54 mm pitch, 500 mA at 30 V DC, 10,000 cycle life. For power and mode selection where the state must be visible at a glance and survive a power cycle.
| Parameter | Value | Unit |
|---|---|---|
| Configuration | SPDT, three positions of travel | |
| Contact rating | 500 | mA at 30 V DC |
| Contact resistance | 30 | mΩ maximum |
| Life | 10,000 | cycles |
| Actuator travel | 2.0 | mm |
| Terminal pitch | 2.54 | mm |
| Mounting | Through-hole, PCB or panel | |
| Body | 8.0 × 4.0 | mm |
| Operating temperature | −20 to +70 | °C |
| Actuator | 0.8 mm protrusion, side or top |
Overview
A slide switch holds its position mechanically, which a pushbutton cannot. When the requirement is that a service technician can see at a glance whether the unit is in run or setup mode, and that the setting survives a power cut, a slide switch is the honest interface.
The rating is modest for a reason. The contacts are small and the wiping action is short, so 500 mA at 30 V is realistic and 2 A is not. For mains or motor loads, use the switch to drive a relay or a MOSFET rather than switching the load directly.
Key features
- Visible, mechanically held position
- SPDT with 2.54 mm pitch, fits standard prototyping
- 500 mA at 30 V DC contact rating
- 10,000 cycle life at rated load
- Top or side actuator, through-hole mounting
Typical applications
- Run, setup and off mode selection
- Battery and supply disconnect
- Configuration jumpers with a visible state
- Test and service overrides
Selection note
Do not use a slide switch for a load above about half an amp. The contacts pit and the resistance rises until the switch behaves like a resistor; drive a relay or MOSFET instead.
Ordering
Send the load voltage and current, actuator orientation and panel thickness. We confirm the rating and mounting, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-SW-T12-THT
Tactile Switch, 12 × 12 mm, Through-Hole, 260 gf, 500k Cycles
DM-SW-PB16-24V