DM-PE-SLOT-5MM
Ask about this product
Send your application details and get a specification answer within one business day.
Phototransistor Optocoupler, 5 kVrms, CTR 50–600%, SOP-4
Phototransistor optocoupler in SOP-4, 5 kVrms isolation, current transfer ratio 50 to 600 percent. For galvanic isolation of digital signals, feedback loops and gate drive interfaces.
| Parameter | Value | Unit |
|---|---|---|
| Isolation voltage | 5,000 | Vrms, 1 minute |
| Current transfer ratio | 50 to 600 | % at IF = 5 mA |
| Forward current | 50 | mA maximum |
| Collector-emitter voltage | 35 | V |
| Collector current | 50 | mA |
| Rise time | 3 | µs typical |
| Fall time | 4 | µs typical |
| Creepage distance | 8 | mm |
| Package | SOP-4, 4.4 mm body | |
| Operating temperature | −55 to +110 | °C |
Overview
An optocoupler breaks the galvanic path with light. There is no shared conductor, no common ground and no path for a fault current to travel from a 400 V bus into a microcontroller, which is the reason the part survives in designs where digital isolators are cheaper and faster.
The CTR is the number that catches people out. It is not a fixed gain: it falls with temperature, falls with age and varies by a factor of ten between parts. A design that works with a nominal CTR of 300 will fail on a unit at the bottom of the 50 percent bin unless the base current is calculated for the worst case.
Key features
- 5 kVrms isolation with 8 mm creepage
- CTR 50 to 600 percent, binned on request
- 3 µs rise time, adequate for signals up to about 100 kHz
- SOP-4 package, half the footprint of a DIP-4
- 35 V collector-emitter rating for direct logic interface
Typical applications
- Digital signal isolation
- Feedback loops in isolated supplies
- Gate drive interfaces for IGBTs and MOSFETs
- Sensor interfaces crossing a safety barrier
Selection note
Design the collector resistor for the minimum CTR at maximum temperature, not the typical value. A circuit sized at CTR 300 will not saturate on a unit at CTR 50 after ten years of degradation.
Ordering
Send the signal rate, isolation voltage, logic levels on both sides and ambient temperature. We confirm CTR bin and package, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-PE-DIF-300
Diffuse Photoelectric Sensor, 300 mm, NPN, IP67
DM-OPT-HS-10M