DM-BJT-D100-8A
Ask about this product
Send your application details and get a specification answer within one business day.
NPN Power Transistor, 100 V, 6 A, TO-220
Power NPN in TO-220, 100 V VCEO and 6 A continuous, 65 W dissipation. Used as a series pass element, relay driver and linear regulator output stage where a switching converter is not justified.
| Parameter | Value | Unit |
|---|---|---|
| Polarity | NPN | |
| Collector-emitter VCEO | 100 | V |
| Collector current | 6 | A continuous |
| Peak collector current | 10 | A |
| DC current gain hFE | 15 to 75 | at IC = 3 A |
| Collector-emitter saturation | 1.5 | V at IC = 6 A, IB = 600 mA |
| Power dissipation | 65 | W at TC = 25 °C |
| Thermal resistance junction-case | 1.9 | °C/W |
| Package | TO-220 | |
| Operating temperature | −65 to +150 | °C |
Overview
A 100 V power bipolar is what gets used when a linear stage has to survive a 48 V rail and a short circuit at the output. It is slower and less efficient than a MOSFET, but it is far harder to destroy: the safe operating area is wide and the part does not fail from a single gate transient.
The limiting factor is thermal, not electrical. At 6 A and 1.5 V saturation the device dissipates 9 W, which on a TO-220 needs a heatsink of about 5 °C/W to stay below a 100 °C junction in 40 °C air. The 65 W rating on the datasheet assumes the case is held at 25 °C, which never happens without forced cooling.
Key features
- VCEO 100 V, 6 A continuous, 10 A peak
- Low saturation voltage for a power bipolar
- TO-220 with isolated mounting option
- Wide safe operating area, tolerant of short-circuit events
- Gain 15 minimum at 3 A, enough for direct base drive from a driver IC
Typical applications
- Linear regulator pass elements
- Relay, solenoid and valve drivers
- Lamp and heater switching
- Constant-current discharge circuits
Selection note
Compute dissipation before choosing a heatsink. A 24 V rail dropping to 12 V at 3 A dissipates 36 W in the transistor, which no TO-220 survives without forced air. In that case a switching converter is the correct answer.
Ordering
Send the rail voltage, load current, duty cycle and ambient temperature. We confirm the thermal calculation and heatsink requirement, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-BJT-P40-200M
PNP Small-Signal Transistor, 40 V, 200 mA, SOT-23
DM-BJT-N40-200M