DM-BJT-D100-8A
Ask about this product
Send your application details and get a specification answer within one business day.
NPN Small-Signal Transistor, 40 V, 200 mA, SOT-23
General-purpose NPN in SOT-23, 40 V VCEO and 200 mA continuous collector current. The default part for level shifting, LED drive and low-side switching on 12 V and 24 V control rails.
| Parameter | Value | Unit |
|---|---|---|
| Polarity | NPN | |
| Collector-emitter VCEO | 40 | V |
| Collector current | 200 | mA continuous |
| DC current gain hFE | 100 to 300 | at IC = 10 mA |
| Collector-emitter saturation | 0.2 | V at IC = 10 mA, IB = 1 mA |
| Transition frequency | 300 | MHz |
| Power dissipation | 350 | mW at TA = 25 °C |
| Package | SOT-23 | |
| Operating temperature | −55 to +150 | °C |
Overview
The 40 V / 200 mA SOT-23 NPN is the part that fills the gaps between a microcontroller pin and a load. A GPIO sources a few milliamps at 3.3 V; a relay coil, a small solenoid or a backlight string needs tens of milliamps at 12 V or 24 V. One transistor and two resistors bridge that gap.
The number that decides whether the circuit works is not hFE on the datasheet front page but hFE at the actual collector current. Gain falls at low current and again at high current, so a part specified at 100 minimum should be driven with roughly twice the base current the nominal gain implies. That is what keeps the transistor in saturation when the batch is cold and the gain is at the bottom of its bin.
Key features
- VCEO 40 V covers 24 V rails with margin for inductive kickback
- 200 mA continuous, 500 mA pulsed collector current
- hFE 100 to 300 at 10 mA, sorted into gain bins on request
- VCE(sat) 0.2 V typical at 10 mA, so dissipation stays under 10 mW
- Standard SOT-23 footprint, pin-compatible with common generic parts
Typical applications
- Relay and solenoid coil drivers
- LED and backlight current switching
- Logic level translation between 3.3 V and 12 V domains
- Signal inversion and simple analogue amplification
Selection note
Add a base-emitter resistor of 10 kΩ to hold the transistor off when the driving pin is floating or tristated during reset. Without it, a controller in reset can switch the load on through leakage.
Ordering
Send the load voltage, load current, drive voltage and switching frequency. We confirm gain bin and package, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-BJT-P40-200M
PNP Small-Signal Transistor, 40 V, 200 mA, SOT-23
DM-BJT-N100-6A