DM-PCB-2L-16
Ask about this product
Send your application details and get a specification answer within one business day.
4-Layer PCB, Controlled Impedance, ENIG, 1.6 mm
Four-layer fabrication with a solid ground plane, controlled impedance to ±10 percent and ENIG finish. For designs with high-speed interfaces, dense routing or EMC requirements that a two-layer board cannot meet.
| Parameter | Value | Unit |
|---|---|---|
| Layers | 4 | layers |
| Stackup | Signal / ground / power / signal | |
| Board thickness | 1.6 | mm ±10% |
| Copper weight | 1 | oz outer, 0.5 oz inner |
| Impedance tolerance | ±10 | % |
| Impedance targets | 50 Ω single-ended, 100 Ω differential | |
| Minimum trace / space | 5 / 5 | mil |
| Minimum drill | 0.25 | mm |
| Surface finish | ENIG, 3 to 6 µm gold | |
| Solder mask | Green or matte black | |
| Electrical test | Impedance coupons plus 100% net test |
Overview
The fourth layer buys a continuous ground plane, and that single change does more for signal integrity than any amount of routing care on a two-layer board. Return currents run directly under their traces, loop area collapses, and radiation drops with it.
Controlled impedance is a manufacturing commitment, not a layout setting. The fabricator adjusts dielectric thickness and trace width so the finished trace measures 50 Ω, and verifies it on a coupon built alongside the panel. Without the coupon the number is a claim rather than a measurement.
Key features
- Four layers with a dedicated ground plane
- Controlled impedance to ±10 percent, verified on coupons
- ENIG finish for fine pitch and long shelf life
- 5/5 mil trace and space, 0.25 mm drill
- Impedance report supplied with the shipment
Typical applications
- High-speed digital and interface boards
- Mixed-signal designs with a separate analogue ground
- Dense SMT assemblies with fine-pitch packages
- EMC-sensitive products
Selection note
Send the stackup and the impedance targets with the Gerber, not after. Impedance is set by the dielectric thickness between layers, so a stackup change after the panel is built means the boards are scrap.
Ordering
Send Gerber, stackup, impedance targets, quantity and finish. We confirm the build against the coupon requirement, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-PCB-FX-2L
2-Layer Flex PCB, Polyimide, 0.2 mm, Stiffeners
DM-PCB-AL-16