DM-PCB-AL-16
Ask about this product
Send your application details and get a specification answer within one business day.
2-Layer Flex PCB, Polyimide, 0.2 mm, Stiffeners
Two-layer polyimide flex circuit, 0.2 mm total thickness, with optional stiffeners and coverlay. For boards that must bend, fold into a housing or survive repeated flexing in a moving assembly.
| Parameter | Value | Unit |
|---|---|---|
| Layers | 2 | layers |
| Base material | Polyimide, 25 µm per layer | |
| Total thickness | 0.2 | mm nominal |
| Copper weight | 0.5 to 1 | oz |
| Minimum trace / space | 4 / 4 | mil |
| Coverlay | Polyimide, 25 µm, or photoimageable | |
| Static bend radius | 6 | × total thickness |
| Dynamic bend radius | 20 | × total thickness |
| Stiffener | FR-4 or polyimide, 0.2 to 1.0 mm | |
| Finish | ENIG or immersion tin |
Overview
A flex circuit removes the connector, the cable and the two solder joints that a rigid board plus harness would need. In a moving assembly that is the difference between a design that lasts the warranty and one that fails at the flex point after a few hundred thousand cycles.
Bend radius is the specification that governs life, and it is measured in multiples of total thickness, not in millimetres. A 0.2 mm circuit bent to a 1.2 mm radius is at six times thickness and will survive static folding but not continuous flexing; the same circuit at a 4 mm radius is at twenty times and will run for millions of cycles.
Key features
- Polyimide construction, 0.2 mm total thickness
- Static bend radius from 6× thickness, dynamic from 20×
- Optional FR-4 or polyimide stiffeners for connector areas
- 4/4 mil trace and space on 1 oz copper
- ENIG or immersion tin finish
Typical applications
- Folding assemblies inside compact housings
- Moving heads, gimbals and robotic joints
- Camera and sensor modules
- Wearable and handheld devices
Selection note
Keep copper runs perpendicular to the bend line and avoid plated through holes inside the bend zone. A via in a flexing area is a stress riser and the usual point of failure.
Ordering
Send Gerber, bend location and radius, flex cycle requirement, stiffener areas and quantity. We confirm the construction and radius against the cycle life, then quote.
No documents attached yet.
Request documentation →Related products
View allDM-PCB-4L-IMP
4-Layer PCB, Controlled Impedance, ENIG, 1.6 mm
DM-PCB-2L-16