DM-IND-100-6A-0808
Ask about this product
Send your application details and get a specification answer within one business day.
TLVR Inductor, 120 nH 50 A, Low DCR
Trans-inductor voltage regulator (TLVR) inductor, 120 nH, 50 A saturation, 0.22 mΩ DCR, with a coupled secondary winding for fast transient response in multiphase VRMs.
| Parameter | Value | Unit |
|---|---|---|
| Primary inductance | 120 | nH |
| Turns ratio | 1:1 | |
| Saturation current | 50 | A |
| DC resistance, primary | 0.22 | mΩ |
| DC resistance, secondary | 0.22 | mΩ |
| Case | 10 × 8 × 8 | mm |
| Shielding | Magnetically shielded | |
| Isolation, primary to secondary | 100 | V DC |
| Operating temperature | −40 to +125 | °C |
| Termination | 4-terminal, Sn-plated |
Overview
A TLVR inductor is a transformer used as an inductor: a primary winding carries the phase current and a secondary winding is connected in a loop across all phases. When one phase sees a load step, the coupled secondaries push current into that phase almost immediately, so the converter responds faster than the switching frequency alone would allow.
The design consequence is that the secondaries form a single series loop around the board. That loop is part of the circuit and must be laid out as a tight, low-inductance path, otherwise the benefit disappears into parasitic ringing. The 120 nH primary value targets high-current CPU and FPGA rails where the transient window is measured in microseconds.
Key features
- Coupled secondary for fast transient injection
- 120 nH primary, 1:1 turns ratio
- 50 A saturation current per phase
- 0.22 mΩ DCR on both windings
- Four-terminal package for a clean secondary loop
Typical applications
- Multiphase VRMs for processor and FPGA rails
- Server and networking point-of-load stages
- Load-step-sensitive AI accelerator supplies
- Compact high-current converters with tight transient limits
Selection note
TLVR only pays off when the secondary loop is laid out as a short, symmetric ring. If the layout cannot support that, a conventional low-DCR inductor is the safer choice.
Ordering
Share the phase count, per-phase current, transient window and available board area. We confirm the inductance and winding ratio against the controller, then quote per phase.
No documents attached yet.
Request documentation →Related products
View allDM-IND-1R5-20A-1010
1.5 µH 20 A Low-Profile Power Inductor, 10 × 10 mm
DM-IND-4R7-10A-1212